Mastertek John Bean Hunter Hofmann Coats Wheel Balancers

Automotive Refinish ECO Concept Single-Skin Downdraft Spray Booth The ECO Concept sets a new level of performance in single-skin waterborne spray booths. Utilizing exclusive features, the ECO Concept has faster drying times, low energy consumption, and the best quality finishes every time! Features include downdraft airflow through the T-Bar ceiling, color-corrected lights, dual VFD’s with Economy Mode, SmartCure control panel, and AdvanceCure. ECO Concept is ecologically friendly, waterborne ready, and delivers the higher profits you’re looking for.

BT1200-RC Recirculating High-Efficiency Heat System		BT12oo High-Efficiency Heat Groups: Designed for indoor use - 10 hp Direct-drive intake motor - 7.5 hp Belt-drive exhaust motor - 34" Tube-axial exhaust fan - 12,000 CFM - 1.2 Million BTU direct-fire burner - Auto pressure control - Twin Variable Frequency Drive (VFD) package CureTronic Control Panel: Easy-to-Use, fully programmable PLC control panel with SmartCure allows custom 'Heat vs. Time' cure cycles.

Cabin Specifications: Internal: 14'w x 9'h x 24'l External: 14'4"w x 11'h x 24'4"l 3-wing Entry Door: 9'8"w x 8'10"h -Full Downdraft airflow for spray and cure -White pre-coated galvanized steel -Rolled-edge panel construction -Eight 4-tube hip-style light fixtures, 120/277V -Four 4-tube sidewall light fixtures, 120/277V -Light wiring harness and limit switch -One personnel access door 32-1/4"w x 7'8"h -Single row exhaust pit -Booth pressure balancing gauge		AdvanceCure Accelerated Airflow System: Adding AdvanceCure to the interior of the booth vastly improves the productivity of the equipment. AdvanceCure introduces controlled turbulence into the paint booth during the flash-off and cure cycles to rapidly draw vapors out of the painted surfaces. This increased airflow dramatically reduces the amount of time required for each paint job, and in turn, increases the profitability of your body shop. AdvanceCure speeds curing of both solvent-based and waterborne paints, so you can be sure that your finishing operation will improve today, and well into the future.

Optional Equipment: ECO CONCEPT Spray Booth Cabin Options: -Cabin extensions to 27' long, with or without lights -Drive-Thru door packages -4-wing entry door upgrades - not including Crossdraft -3 row exhaust pit or raised basement - Downdraft only -Additional personnel access doors -Paint mix rooms available in free-standing, attached, or vestibule designs -Cabins designed to accept fire suppression systems BT1200 Optional Equipment: -1.5 million BTU upgrade -15hp intake motor upgrade -Natural Gas or propane fuel options -Side, rear, or roof-mounted units available		Code Compliance: NFPA-33 Standard for spray application using flammable or combustible materials NFPA-86 Standard for ovens and furnaces NFPA-91 Standard for exhaust systems for air conveying of materials NFPA-101 Life Safety Code NFPA-70 National Electric Code OSHA Safety and Health Standards (29 CFR 1910, 1910.107) BOCA National Fire Prevention Code; National Building Code; National Mechanical Code ICBO Uniform Fire Code Article 45 SBCCI Standard Fire Prevention Code ICC International Building Code ICC International Fire Code Chapter 15 This booth has been reviewed and approved by: ETL Equipment Testing Laboratory report # 3049856 Cabin All Fixtures are ETL approved for hazardous locations. All light fixtures are accessible from the interior of the spray booth and conform to the provisions of N.F.P.A. 33. Electrical components, such as motors, motor starters, disconnect switches and push buttons, are listed or approved for the Class and Division in which they are located. Motors UL recognized PRGYZ, Marathon Electric file E49747 (or equal), Glass used in the spray booth is tempered and meets and exceeds ANSI Z-97.1 standard. Conformance to all these requirements is dependent upon the manner in which the equipment is installed. The contractor will make certain that all the electrical wiring and conduit, piping, gas supply, roof penetrations, automatic fire penetrations, automatic fire protection systems, and the location of the equipment within the building also conforms to the cited codes and other references. Fire suppression system is NOT included with the standard booth but is required by NFPA-33.